首页 运维 网络学院 查看内容

构建SAN网络存储

2013-4-18 11:37 790 0

摘要:   实验目的:构建SAN网络存储  实验环境:redhat 5.4三台,scanstorage作为存储服务,IP地址是:192.168.9.79。node1,node2作为客户端测试  实验步骤:  ...
关键词: root iscsi scanstorage cylinders node dev 配置 192.168 redhat Disk

  实验目的:构建SAN网络存储  实验环境:redhat 5.4三台,scanstorage作为存储服务,IP地址是:192.168.9.79。node1,node2作为客户端测试  实验步骤:  一、配置服务端:  1、添加一块20G的盘  [root@scanstorage ~]# fdisk -l |grep Disk  Disk /dev/sdc: 21.4 GB, 21474836480 bytes  2、在RHEL5中安装如下的包:  iscsi-initiator-utils-6.2.0.868-0.18.el5.i386.rpm  perl-Config-General-2.40-1.el5.noarch.rpm  scsi-target-utils-0.0-5.20080917snap.el5.i386.rpm (这个包在光盘的cluster storage目录下)  [root@scanstorage ~]# yum -y install iscsi-initiator-utils perl-Config-General scsi-target-utils  3、通过linux中的命令生成IQN编号  [root@scanstorage ~]# iscsi-iname  iqn.1994-05.com.redhat:a3c8bc769291  4、编辑配置文件  [root@scanstorage ~]# vim /etc/tgt/targets.conf  <target iqn.1994-05.com.redhat:4d4fa666619>  backing-store /dev/sdb  </target>  5、启动服务  [root@scanstorage ~]# /etc/init.d/tgtd start  Starting SCSI target daemon: Starting target framework daemon  6、查看配置信息  [root@scanstorage ~]# tgtadm --lld iscsi --op show --mode target  Target 1: iqn.1994-05.com.redhat:bc2c8763fcdb  System information:  Driver: iscsi  State: ready  I_T nexus information:  LUN information:  LUN: 0  Type: controller  SCSI ID: IET 00010000  SCSI SN: beaf10  Size: 0 MB  Online: Yes  Removable media: No  Backing store type: rdwr  Backing store path: None  LUN: 1  Type: disk  SCSI ID: IET 00010001  SCSI SN: beaf11  Size: 21475 MB  Online: Yes  Removable media: No  Backing store type: rdwr  Backing store path: /dev/sdb  Account information:  ACL information:  ALL  [root@scanstorage ~]#  以上就是ISCSI服务的配置,注意,ISCSI的链接端口是3260,保证防火墙正常通过。接下来我们配置客户端。  二、配置客户端  客户端的配置的时候只需要安装一个ISCSI Initiator的包即可。以node1,node2为例:  1、安装包  [root@node1 ~]# yum -y install iscsi-initiator-utils  [root@node2 ~]# yum -y install iscsi-initiator-utils  2、使用iSCSI存储  [root@node1 ~]# iscsiadm -m discovery -t st -p 192.168.9.79  192.168.9.79:3260,1 iqn.1994-05.com.redhat:bc2c8763fcdb  [root@node2 ~]# iscsiadm -m discovery -t st -p 192.168.9.79  192.168.9.79:3260,1 iqn.1994-05.com.redhat:bc2c8763fcdb  在node1和node2上开启服务如下服务:iscsid network iscsi netfs,然后登录:  [root@node1 ~]# iscsiadm -m node -T iqn.1994-05.com.redhat:bc2c8763fcdb -p 192.168.9.79 -l  [root@node1 ~]# fdisk -l  Disk /dev/sda: 32.2 GB, 32212254720 bytes  255 heads, 63 sectors/track, 3916 cylinders  Units = cylinders of 16065 * 512 = 8225280 bytes  Device Boot Start End Blocks Id System  /dev/sda1 * 1 3393 27254241 83 Linux  /dev/sda2 3394 3915 4192965 82 Linux swap / Solaris  Disk /dev/sdb: 21.4 GB, 21474836480 bytes64 heads, 32 sectors/track, 20480 cylinders  Units = cylinders of 2048 * 512 = 1048576 bytes  Disk /dev/sdb doesn't contain a valid partition table  [root@node1 ~]# iscsiadm -m node -T iqn.1994-05.com.redhat:bc2c8763fcdb -p 192.168.9.79 -l  [root@node2 ~]# fdisk -l  Disk /dev/sda: 32.2 GB, 32212254720 bytes  255 heads, 63 sectors/track, 3916 cylinders  Units = cylinders of 16065 * 512 = 8225280 bytes  Device Boot Start End Blocks Id System  /dev/sda1 * 1 3393 27254241 83 Linux  /dev/sda2 3394 3915 4192965 82 Linux swap / Solaris  Disk /dev/sdb: 21.4 GB, 21474836480 bytes64 heads, 32 sectors/track, 20480 cylinders  Units = cylinders of 2048 * 512 = 1048576 bytes  Disk /dev/sdb doesn't contain a valid partition table
声明:文章版权归原作者所有 部分文章转自互联网 如有侵权请联系 [邮箱地址] 删除

路过

雷人

握手

鲜花

鸡蛋

最新评论

返回顶部